below commit mapped 16 MB memory from the start of DRAM(0x80000000),
which may have conflict with the shared memory used by Trusty OS:
LF-8819: plat: imx8ulp: ddrc switch auto low power and software interface
change the mapped memory to 'vdev0buffer' reserved memory (0x8ff00000)
to avoid memory conflict. This commit also bumps the XTLB tables
to avoid mapping failure.
Signed-off-by: Ji Luo <ji.luo@nxp.com>
Change-Id: I1a7af958af47e3fc9955d0a80d1649971e843eab
Enable switch between DDRC Auto low power and software/hardware
control modes DDRC Auto low-power mode is used when system is
active, software/hardware control mode is used when going into
suspend. Enable switching between Auto mode and SW/HW mode in
enter/exit retention routines.
Set LPI_SRPD_LONG_MCCLK_GATE_WAKEUP_F2 Max setting to allow
LPDDR_EN_CLKGATE reload LPI_SRPD_LONG_MCCLK_GATE_WAKEUP_F2 to
exit retention mode
Signed-off-by: Pascal Mareau <pascal.mareau@nxp.com>
Signed-off-by: Adrian Alonso <adrian.alonso@nxp.com>
Signed-off-by: Hongting Ting <hongting.dong@nxp.com>
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Change-Id: I3c4b6f7bc6ca02649ff27cd3d9a0c50dab3a3ad0
When system level DVFS is enabled, voltage can be changed to
optimize the power consumption.
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: Idfa0e637402078f3daf6e7c4ea1abb9af7675494
Enable the DDR frequency scaling support on i.MX8ULP.
Normally, the freq_index define is as below:
0: boot frequency;
1: low frequency(PLL bypassed);
2. high frequency(PLL ON).
Currently, DDR DFS only do frequency switching between
Low freq and high freq.
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: I3acd8bdf75e2dd6dff645b9f597dcfc0a756c428
The APD can be put into PD mode when linux suspend(mem). This patch
add the support for it. As the whole AP domain's context will be lost,
so we must save the necessary HW module states before entering PD mode,
and we need to restore those contexts when system wake up. Fot details
about which HW module's state will be lost, please refer to the RM.
When APD enter PD mode, only the wakeup event connected to the WUU
can wakeup APD successfully. The upower wakeup source is used to
wakeup APD by RTD due to the factor that the MU between A core & M
core is not connected into WUU to generate wakeup event.
as the SRAM0 will be power down when APD enters PD mode, so we
need to re-init the scmi channels(resides in the SRAM0). otherwise
the SCMI can NOT work anymore.
Signed-off-by: Jacky Bai <ping.bai@nxp.com>
Reviewed-by: Ye Li <ye.li@nxp.com>
Change-Id: I44b0cdc8397e5d6a82081ea6746542e9fa4b9fc1
