mirror of
https://github.com/ARM-software/arm-trusted-firmware.git
synced 2025-04-16 17:44:19 +00:00
30e8bc365c
Add support for JTAG Debug Communication Channel(DCC), using the dcc console driver, for Versal NET platform. UART0/UART1 is not configured when the JTAG DCC is used as console for the platform. Though DCC is not using any UART, VERSAL_NET_UART_BASE needs to be defined in the platform code. If its not defined, build errors are observed. Now VERSAL_NET_UART_BASE by default points to UART0 base. Check for valid console(pl011, pl011_0, pl011_1, dcc) is being done in the platform makefile, the error condition in setting the value of VERSAL_NET_UART_BASE is redundant, thus the error message is removed from the code. Change-Id: I1085433055abea13526230cff4d4183ff7a01477 Signed-off-by: Akshay Belsare <akshay.belsare@amd.com>
37 lines
1.4 KiB
ReStructuredText
37 lines
1.4 KiB
ReStructuredText
Xilinx Versal NET
|
|
=================
|
|
|
|
Trusted Firmware-A implements the EL3 firmware layer for Xilinx Versal NET.
|
|
The platform only uses the runtime part of TF-A as Xilinx Versal NET already
|
|
has a BootROM (BL1) and PMC FW (BL2).
|
|
|
|
BL31 is TF-A.
|
|
BL32 is an optional Secure Payload.
|
|
BL33 is the non-secure world software (U-Boot, Linux etc).
|
|
|
|
To build:
|
|
```bash
|
|
make RESET_TO_BL31=1 CROSS_COMPILE=aarch64-none-elf- PLAT=versal_net bl31
|
|
```
|
|
|
|
To build TF-A for JTAG DCC console:
|
|
```bash
|
|
make RESET_TO_BL31=1 CROSS_COMPILE=aarch64-none-elf- PLAT=versal_net VERSAL_NET_CONSOLE=dcc bl31
|
|
```
|
|
|
|
Xilinx Versal NET platform specific build options
|
|
-------------------------------------------------
|
|
|
|
* `VERSAL_NET_ATF_MEM_BASE`: Specifies the base address of the bl31 binary.
|
|
* `VERSAL_NET_ATF_MEM_SIZE`: Specifies the size of the memory region of the bl31 binary.
|
|
* `VERSAL_NET_BL32_MEM_BASE`: Specifies the base address of the bl32 binary.
|
|
* `VERSAL_NET_BL32_MEM_SIZE`: Specifies the size of the memory region of the bl32 binary.
|
|
|
|
* `VERSAL_NET_CONSOLE`: Select the console driver. Options:
|
|
- `pl011`, `pl011_0`: ARM pl011 UART 0 (default)
|
|
- `pl011_1` : ARM pl011 UART 1
|
|
- `dcc` : JTAG Debug Communication Channel(DCC)
|
|
|
|
* `TFA_NO_PM` : Platform Management support.
|
|
- 0 : Enable Platform Management (Default)
|
|
- 1 : Disable Platform Management
|