mirror of
https://github.com/ARM-software/arm-trusted-firmware.git
synced 2025-04-16 17:44:19 +00:00
![]() * changes: docs(maintainers): add the maintainers for imx8ulp docs(imx8ulp): add imx8ulp platform fix(imx8ulp): increase the mmap region num feat(imx8ulp): adjust the dram mapped region feat(imx8ulp): ddrc switch auto low power and software interface feat(imx8ulp): add some delay before cmc1 access feat(imx8ulp): add a flag check for the ddr status fix(imx8ulp): add sw workaround for csi/hotplug test hang feat(imx8ulp): adjust the voltage when sys dvfs enabled feat(imx8ulp): enable the DDR frequency scaling support fix(imx8ulp): fix suspend/resume issue when DBD owner is s400 only feat(imx8ulp): update XRDC for ELE to access DDR with CA35 DID feat(imx8ulp): add memory region policy feat(imx8ulp): protect TEE region for secure access only feat(imx8ulp): add trusty support feat(imx8ulp): add OPTEE support feat(imx8ulp): update the upower config for power optimization feat(imx8ulp): allow RTD to reset APD through MU feat(imx8ulp): not power off LPAV PD when LPAV owner is RTD feat(imx8ulp): add system power off support feat(imx8ulp): add APD power down mode(PD) support in system suspend feat(imx8ulp): add the basic support for idle & system suspned feat(imx8ulp): enable 512KB cache after resume on imx8ulp feat(imx8ulp): add the initial XRDC support feat(imx8ulp): allocated caam did for the non secure world feat(imx8ulp): add i.MX8ULP basic support build(changelog): add new scopes for nxp imx8ulp platform feat(scmi): add scmi sensor support |
||
---|---|---|
.. | ||
allwinner | ||
amlogic | ||
arm | ||
auth | ||
brcm | ||
cadence | ||
cfi/v2m | ||
clk | ||
console | ||
coreboot/cbmem_console/aarch64 | ||
delay_timer | ||
fwu | ||
gpio | ||
imx | ||
intel/soc/stratix10/io | ||
io | ||
marvell | ||
measured_boot | ||
mentor/i2c | ||
mmc | ||
mtd | ||
nxp | ||
partition | ||
rambus | ||
renesas | ||
rpi3 | ||
scmi-msg | ||
st | ||
synopsys | ||
ti/uart | ||
ufs | ||
usb |