This patch renames symbols and files relating to CVE-2017-5715 to make
it easier to introduce new symbols and files for new CVE mitigations.
Change-Id: I24c23822862ca73648c772885f1690bed043dbc7
Signed-off-by: Dimitris Papastamos <dimitris.papastamos@arm.com>
This patch implements a fast path for this SMC call on affected PEs by
detecting and returning immediately after executing the workaround.
NOTE: The MMU disable/enable workaround now assumes that the MMU was
enabled on entry to EL3. This is a valid assumption as the code turns
on the MMU after reset and leaves it on until the core powers off.
Change-Id: I13c336d06a52297620a9760fb2461b4d606a30b3
Signed-off-by: Dimitris Papastamos <dimitris.papastamos@arm.com>
In the initial implementation of this workaround we used a dedicated
workaround context to save/restore state. This patch reduces the
footprint as no additional context is needed.
Additionally, this patch reduces the memory loads and stores by 20%,
reduces the instruction count and exploits static branch prediction to
optimize the SMC path.
Change-Id: Ia9f6bf06fbf8a9037cfe7f1f1fb32e8aec38ec7d
Signed-off-by: Dimitris Papastamos <dimitris.papastamos@arm.com>
Invalidate the Branch Target Buffer (BTB) on entry to EL3 by
temporarily dropping into AArch32 Secure-EL1 and executing the
`BPIALL` instruction.
This is achieved by using 3 vector tables. There is the runtime
vector table which is used to handle exceptions and 2 additional
tables which are required to implement this workaround. The
additional tables are `vbar0` and `vbar1`.
The sequence of events for handling a single exception is
as follows:
1) Install vector table `vbar0` which saves the CPU context on entry
to EL3 and sets up the Secure-EL1 context to execute in AArch32 mode
with the MMU disabled and I$ enabled. This is the default vector table.
2) Before doing an ERET into Secure-EL1, switch vbar to point to
another vector table `vbar1`. This is required to restore EL3 state
when returning from the workaround, before proceeding with normal EL3
exception handling.
3) While in Secure-EL1, the `BPIALL` instruction is executed and an
SMC call back to EL3 is performed.
4) On entry to EL3 from Secure-EL1, the saved context from step 1) is
restored. The vbar is switched to point to `vbar0` in preparation to
handle further exceptions. Finally a branch to the runtime vector
table entry is taken to complete the handling of the original
exception.
This workaround is enabled by default on the affected CPUs.
NOTE
====
There are 4 different stubs in Secure-EL1. Each stub corresponds to
an exception type such as Sync/IRQ/FIQ/SError. Each stub will move a
different value in `R0` before doing an SMC call back into EL3.
Without this piece of information it would not be possible to know
what the original exception type was as we cannot use `ESR_EL3` to
distinguish between IRQs and FIQs.
Change-Id: I90b32d14a3735290b48685d43c70c99daaa4b434
Signed-off-by: Dimitris Papastamos <dimitris.papastamos@arm.com>
